Ywrobot power supply

Vi hjälper dig jämföra produkter, priser och återförsäljare online. Brett utbud med filmer, serier och barnens favoriter! Njut av filmer i högsta kvalitet, livesport och populära serier på Viaplay.

V power rails, and has a USB socket. There are two power supply ports on the left side, a DC port and a USB port. On the right side, there are two ports of power output. You can switch the power voltage of both ports between 3. V and 5V by the jumper cap. V or 5V can be individually selected for the different power rails.

Can supply up to 400mA of current. See table below for. Input voltage of 6. V, 5V on breadboard power rails (J JJJ7), GN 3. Power outputs: GN 3. So apparently it works both ways - as an input power supply and an output power supply ! V at the same time which was a great addition for any prototyping which typically need 5v, 3. Buy the best and latest ywrobot breadboard power supply on banggood.

I have adruino uno, usb water fountains, and yw robot USB power supply (as my power output). Since im powering the fountain using the ywrobot usb, can i wire it directly to my uno withouth diode, resistor, and trnsister? I am new , so please help. Read Online Ywrobot power. V to 12V input and can produce 3. Can also output 5V on USB connector and can also take input through USB connector.

The module can take 6. Learn How to interface a YwRobot Vibration Sensor with Arduino. Switch on the power supply as soon as the device has been supplied with GND and 5V DC. Dimensions should be 2. You can use a couple of alkaline batteries directly connected to the ESP, but the ESP will fail as the batteries get flat and the voltage drops to around 2. Requires soldering and assembly. No assembly manual provided. V regulated voltage.

Just another model I thought people might find useful. I have included a model with the power switch in the ON position as well as the OFF position. Accepts inputs of 6. Plugs into standard breadboards. Branded YwRobot , this tiny power supply modules makes breadboad prototyping a lot more straight forward.

Simply plug this module into the end of a standard breadboard to give dual volt and or 3. Using the the onboard jumpers, a combination of dual supplies can be selecte giving either 2x 3. This is especially handy because there are many devices (example – ESP chips and breakout boards) that only run on 3. V 는 물론이거니와 USB를 통한 전원도 공급하는 모양입니다. Breadboard power supply module, compatible with 5V, 3. V (DC) or USB power supply Output voltage: 3. В интернет магазине Arduino-kit.